Home > Knowledge > Content
Kindergarten artificial turf laying steps
Dec 08, 2018

Kindergarten playground area is generally small, children's activities are relatively small, so the use of landscape leisure grass, mainly to play a beautiful role, kindergarten artificial turf and football field lawn and other sports, the construction is relatively simple, without any paving experience People can also shop, and they can save a lot of paving costs.


According to the basic requirements of site use, the basis is asphalt concrete foundation, cement concrete foundation, tile tile floor or 10% cement stone powder foundation layer after curing to meet the requirements, followed by laying artificial turf, the main construction process is as follows:

1. Check the entire turf field to be laid, whether the basic compactness and flatness meet the requirements, and clean up the site. 2, paving artificial turf, in order to make the folds of the lawn naturally stretch, it is recommended to put the artificial turf under the sun for half a day, and pay attention to the direction of the lawn. Note: Pay attention to the lawn to be consistent during the laying process.

3. Start laying artificial turf: a special splicing tape is placed on the turf joint surface and fixed on it with glue. The joint area needs to be overlapped by more than 10 cm.

4. Apply glue to the joint interface. Before the glue dries, cut and join the cut lawn so that each artificial lawn is tightly bonded.

5. Cut off the black edge of the lawn with a utility knife and trim the seams of the lawn.

6, the details of the corner processing, and strive to achieve excellence.

7. Bond the joints and tap the pressure with a rubber mallet to make the bond more tight.

8. After the laying is completed, it is necessary to carefully check whether the bonding of each joint area is smooth, and whether the artificial grass is firmly bonded. After the inspections meet the requirements, the sanitary exit can be cleaned up.


Tips:  

1. Gluing: It is required to use a brush to paint the back of the turf with a uniform thickness and no repeated application of glue. Otherwise, foaming may occur or even fall. When applying glue to the base fabric, the thickness of the glue should be strictly controlled. Pay attention to the proper speed of the glue. When applying the glue, apply it to the two bonding surfaces that are bonded.

Second, bonding: According to the actual influence of temperature, humidity, pressure and other conditions at that time, reasonable control of drying time, generally 10-30 minutes after the application of glue, the glue reaches 890% dry and the hand touch is not sticky. It is required to adhere to the one-time alignment when bonding, and it is not allowed to move the bonded object back and forth after bonding.

 3. Pressurization: After bonding, remove the surface debris, and use a special rubber hammer to hammer the two sides from the joint, so that the surface is fully contacted and dense, and the bonding is firmer.